SilaCast Beauty Enhancing Sealer is the first biodegradable paver sealer to take the country by storm!!!
While other products leave a shiny gloss on the surface SilaCast actually penetrates deep in the pores of the pavers enhancing the color and leaving your pavers beautifully wet looking.
Extremely low VOC alkyd latex emulsion that creates a wet look appearance and revitalizes the color of interior and exterior porous surfaces such as concrete pavers and tiles, natural and artificial stone and brick. Desired applications include patios, pool decks, concrete pavers, decorative concrete and artificial/natural stone walls.
SILACAST IS BUILT GREEN - EASY TO APPLY, NON-HAZARDOUS, ENVIRONMENTALLY FRIENDLY!
Pavers, Concrete, Stamped Concrete, Stone Tile, Natural and Artificial Stone, Clay Tiles, Masonry Brick and Block.
Creates a wet look appearance, it enhances the dull color of sun worn pavers, etc. When applied it's a milky white appearance. Dries clear when penetrating into substrate. 1 or 2 coat application is sufficient depending on porosity of substrate.
Apply Silicast without dilution to porous concrete, tile, masonry, unglazed tile, natural or artificial stone, clay roof tiles, brick surfaces with a low pressure pneumatic canister or garden type pump sprayer. Use a fine mist setting and apply to substrate until wet, avoiding drips and runs. Product can be re-applied within 2hrs. Allow a minimum of 24 hrs before walking on and 48 hrs before driving on.
Preparation includes repairing all cracked and damaged grout lines, clean surface with hose wash or power wash removing all loose dirt, oils, etc. Allow plenty of time to dry to prevent trapping moisture behind coating and harming products effectiveness.
ALWAYS PERFORM A SAMPLE TEST FIRST TO APPLICATION TO ENSURE DESIRED RESULTS!!
Chemical and Hot Tire Resistance, Excellent Adhesion, Water Blushing Resistant, UV Protected
Chemical Resistance on Cementitious Backer Board 24 Hr. spot test / 48 Hr. recovery:
- Gasoline - No Effect
- Engine Oil - Slightly Darkened
- Transmission Fluids - Slightly Darkened
- Sodium Hydroxide - No Effect
- Ethanol - No Effect
- Brake Fluid - No Effect
- Antifreeze - Very Slightly Darkened
- Bleach - No Effect
- Salt Water / 5% Solution - No Effect
NOTE: Silicast performance is comparable to commercially available solvent borne wet look sealers. Solvent sealers have high fumes, cause headaches, irritation to eyes, etc. Silicast is a water based product and built green for the environment.
1 gallon = 125 sq.ft or 5 gal pail = 625 sq.ft.
All substrates vary with different porosity rates. Stone is more dense than brick therefore coverage rates on stone will be higher than brick.